Ic 353 datasheet

For Typical Characteristic Performance Curves, refer to MC34001, 34002, 34004 data sheet. NOTE: 3.Input bias currents of JFET input op amps approximately double for every 10 °C rise in junction temperature. To maintain junction temperatures as close to ambient as is possible, pulse techniques are utilized during test.

Model 353 is ideal for applications such as broadband access, Ethernet/Gigabit Ethernet, SONET/SDH, xDSL, PCMIA, digital video, Picocells and base stations. Document No. 008-0369-0 Page 2 - 3 Rev.

Q.PEAK DUO L-G5. 2 380-395 1 APT test conditions according to IEC/TS 62804-1:2015, method B (˜ 1500 , V168 h)2 See data sheet on rear for further information. Q.ANTUM SOLAR MODULE BC557, 557B General Purpose Transistor Page 3 31/05/05 V1.0 Parameter Symbol Test Condition Rating Unit Collector Emitter Saturation Voltage VCE(Sat) IC = 10mA, IB = 0.5mA IC = 100mA, IB = 5mA The Beckman (Beckman acquired in 1973 Sperry Information Displays Division, Scottsdale, AZ) SP-352, SP-353 displays are raised-cathode, planar-gas-discharge displays. Units of equal character height can be stacked vertically or horizontally to make any desired message field while maintaining continuous inter-character spacing. Data sheet status Objective specification This data sheet contains target or goal specifications for product development. Preliminary specification This data sheet contains preliminary data; supplementary data may be published later. Product specification This data sheet contains final product specifications. Limiting values Output short-circuit protection High input impedance JFET input stage Internal frequency compensation Latch up free operation High slew rate 16 V/µs (typical) Description These circuits are high speed JFET input single operational amplifiers incorporating well matched, high voltage JFET and bipolar transistors in a

a jumper across the S33-S34 circuit, and therefore does not perform output monitoring. The outputs are only 2 normally open safety rated outputs. The safety outputs have independent and redundant internal contacts to help ensure the safety function. Features Category 4 per EN 954-1 Stop category 0 2 Safety contacts N.O.